Policy Condition Destination Port Group - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

policy condition destination port group

policy condition destination port group
Associates a destination port group with a policy condition. Use the no form of the command to remove a
destination port group from a condition.
policy condition condition_name destination port group group_name
policy condition condition_name no destination port
Syntax Definitions
condition_name
group_name
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
Use the no form of the command to remove a destination port group from a condition; however, at least
one classification parameter must be associated with a condition.
Examples
-> policy condition cond6 destination port group portgr4
Release History
Release 7.1.1; command was introduced.
Related Commands
policy port group
qos apply
policy condition
show policy condition
page 26-112
The name of the condition. May be an existing condition name or a new
condition.
The name of the destination port group. Port groups are configured
through the policy port group
Configures a port group and its associated slot and port numbers.
Applies configured QoS and policy settings to the current configuration.
Creates a policy condition.
Shows information about policy conditions configured on the switch.
QoS Policy Commands
command.
OmniSwitch CLI Reference Guide March 2011