Qos Port Trusted - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

qos port trusted

qos port trusted
Configures whether an individual port is trusted or untrusted. Trusted ports can accept the 802.1p and ToS/
DSCP values in incoming packets; untrusted ports will set any 802.1p or ToS/DSCP values to zero in
incoming packets, unless a default 802.1p or ToS/DSCP value is configured.
qos port slot/port[-port] trusted
qos port slot/port no trusted
Syntax Definitions
slot/port[-port]
Defaults
By default, all ports are untrusted.
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the qos trust ports
command may be used to override the default.
•
The setting applies only to ports with incoming traffic.
•
Use the qos port default 802.1p
zero should be applied to the incoming packets. Note that this value is overridden if a policy exists that
specifies a different 802.1p or ToS/DSCP value for such packets.
Examples
-> qos port 3/1 trusted
-> qos port 4/2 no trusted
Release History
Release 7.1.1; command was introduced.
page 25-32
The slot number and port number of the physical port. Use a hyphen to
specify a range of ports (4/1-8).
command to set the default trust mode for all QoS ports. The qos port trusted
or qos port default dscp commands to specify that a value other than
OmniSwitch CLI Reference Guide
QoS Commands
March 2011