Qos Qset - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

QoS Commands

qos qset

Configures the QSet profile (QSP) parameters for the specified profile (QSP 1–4). A QSet refers to a set
of eight virtual output queues (VOQs) that is associated with each switch port and link aggregate (LAG).
VOQ management is implemented using a QSet framework. The QSet profile (QSP) defines the QoS
behavior for the QSet instance (QSI) associated with the profile.
qos qset {qsp-id qsp_id | qsp-name qsp_name} [wrp-id wrp_id | wrp-name wrp_name] [wred-admin
{enable | disable}] [stats-admin {enable | disable}]
Syntax Definitions
qsp_id
qsp_name
wrp_id
wrp_name
wred-admin enable
wred-admin disable
stats-admin enable
stats-admin disable
Defaults
•
There are four pre-defined QSet profiles (QSP 1–4) that are configured with the following QSet param-
eter values:
parameter
qsp_id
qsp_name
wrp_id
wrp_name
wred-admin {enable | disable}
stats-admin {enable | disable}
•
Each of the four profiles is pre-configured with a different queuing scheme for the associated queues.
See the "Configuring QoS" chapter in the OmniSwitch AOS Release 7 Network Configuration Guide
for more information.
Platforms Supported
OmniSwitch 10K
OmniSwitch CLI Reference Guide
A QSet profile (QSP) ID number. The valid range is 1–4.
The QSet profile name (qsp-1, qsp-2, qsp-3, or qsp-4).
The WRED profile (WRP) ID to associate with the QSet profile.
The name of the WRED profile to associate with the QSet profile.
Enables the associated WRED profile for the QSet profile.
Disables the associated WRED profile for the QSet profile.
Enables scheduling statistics collection for the QSet queues.
Disables scheduling statistics collection for the QSet queues.
default
1-4
qsp-id
1
wrp-1
enabled
disabled
March 2011
qos qset
page 25-49