Ntp Key Load - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

Network Time Protocol Commands

ntp key load

Loads the current key file into memory.
ntp key load
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
This command reloads the key file into the switch memory. This allows for new keys in the key file to
be added to the list of keys the switch can use for authentication.
•
Newly added keys must be labeled as trusted with the
authentication.
•
By default, all authentication keys are untrusted therefore reloading a key file will change any current
trusted keys to untrusted status.
•
The file ntp.keys is used during the establishment of a set of authentication keys that are used by the
NTP protocol. The location of this file is fixed in directory /flash/network.
Examples
-> ntp key load
Release History
Release 7.1.1; command was introduced.
Related Commands
ntp key
ntp server
MIB Objects
alaNtpAccessRereadkeyFile
OmniSwitch CLI Reference Guide
Labels the specified authentication key identification as trusted or
untrusted.
Specifies an NTP server from which this switch will receive updates.
March 2011
ntp key command before being used for
ntp key load
page 40-13