Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual page 1992

ethernet-service uni-profile
Usage Guidelines
•
Use the no form of this command to delete a UNI profile.
•
Remove any UNI profile associations with UNI ports before attempting to modify or delete the profile.
•
Up to five unique UNI profile combinations, including the default profile, are allowed per switch. If a
profile has the same processing settings as any other profile, then it is not considered unique.
•
Not all of the protocol parameters are currently supported with the peer, tunnel, and discard
parameters. Use the following table to determine the parameter combinations that are supported:
stp
802.1x
802.3ad
802.1ab
mvrp
amap
•
If a user-configured UNI profile is not associated with a UNI port, then the default profile
(default-uni-profile) is used to process control packets ingressing on the port.
•
A uni-profile cannot be modified if it is associated with a UNI. The uni-profile cannot be deleted unless
the associations are deleted.
Examples
-> ethernet-service uni-profile uni_1 l2-protocol stp mvrp discard
-> no ethernet-service uni-profile uni_1
Release History
Release 7.1.1; command introduced.
Related Commands
ethernet-service uni uni-profile
ethernet-service sap uni
show ethernet-service uni
show ethernet-service uni-
profile
page 34-24
peer discard
no yes
yes yes
yes yes
yes yes
no yes
no yes
Associates a VLAN Stacking UNI profile with a UNI port.
Configures the switch port as a VLAN Stacking UNI and associates the
port with a VLAN Stacking Service Access Point (SAP).
Displays the profile associations for VLAN Stacking UNI ports.
Displays the profile attribute configuration for VLAN Stacking UNI
profiles.
tunnel
yes
yes
yes
yes
yes
no
OmniSwitch CLI Reference Guide
VLAN Stacking Commands
March 2011