Ip Pim Candidate-Rp - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

PIM Commands

ip pim candidate-rp

Configures the local router as the Candidate-Rendezvous Point (C-RP) for a specified IP multicast
group(s).
ip pim candidate-rp rp_address group-address/prefix_length [priority priority] [interval seconds]
no ip pim candidate-rp rp_address group-address/prefix_length
Syntax Definitions
rp_address
group_address
/prefix_length
priority
seconds
Defaults
parameter
priority
seconds
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to remove the association of the device as a C-RP for a particular
multicast group.
•
The specified rp_address must belong to a PIM enabled interface.
•
Only one RP address is supported per switch. If multiple candidate-RP entries are defined, they must
specify the same rp-address.
•
The priority and the interval values are used by the switch. If they are modified for one entry, the
switch will modify these for all the candidate-rp entries.
•
This command is supported only in the sparse mode.
Examples
-> ip pim candidate-rp 50.1.1.1 224.0.0.0/4 priority 100 interval 100
OmniSwitch CLI Reference Guide
Specifies a 32-bit address that will be advertised as a Candidate-RP.
Specifies a 32-bit group address for which the local router will adver-
tise itself as a Candidate-RP.
Specifies the prefix length of the multicast group.
Specifies the priority value of the Candidate-RP. Values may range
from 0 to 192. The lower the value, the higher the priority.
Specifies the interval at which the C-RP advertisements are sent to the
bootstrap router, in seconds. Values may range from 1 to 300.
default
192
60
March 2011
ip pim candidate-rp
page 23-15