ip pim dense admin-state
ip pim dense admin-state
Globally enables or disables PIM-DM protocol on the switch.
ip pim dense admin-state {enable | disable}
Syntax Definitions
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
This command must be set to enable before PIM-DM can run on the switch. In addition, the ip load
pim command must be executed. Refer to
•
The advanced routing image file must be loaded to flash before the feature will start to work on the
switch.
Examples
-> ip pim dense admin-state enable
-> ip pim dense admin-state disable
Release History
Release 7.1.1; command was introduced.
Related Commands
ip pim interface
ip load pim
show ip pim dense
MIB Objects
alaPimdmGlobalConfig
alaPimdmAdminStatus
page 23-6
Globally enables PIM-DM on the switch.
Globally disables PIM-DM on the switch.
default
disable
page 23-3
for more information.
Enables or disables the PIM protocol on a specific interface.
Dynamically loads PIM to memory.
Displays the status of the various global parameters for the PIM
dense mode.
OmniSwitch CLI Reference Guide
PIM Commands
March 2011