policy condition ip-protocol
policy condition ip-protocol
Configures an IP protocol for a policy condition.
policy condition condition_name ip-protocol protocol
policy condition condition_name no ip-protocol
Syntax Definitions
condition_name
protocol
Defaults
parameter
protocol
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of the command to remove a protocol from a condition; however, at least one classifi-
cation parameter must be associated with a condition.
•
If a source or destination port is specified (through the policy condition source ip port or policy
condition destination ip port commands), the protocol must be specified.
•
The same condition cannot specify an IP protocol with a service or service group.
Examples
-> policy condition cond4 ip protocol 6
Release History
Release 7.1.1; command was introduced.
Related Commands
policy condition source ip-port
policy condition destination ip-
port
qos apply
show policy condition
page 26-78
The name of the condition.
The protocol associated with the flow. The range is 0–255.
default
6
Configures a source IP port number for a policy condition.
Configures a destination IP port number for a policy condition.
Applies configured global QoS and policy settings to the current config-
uration (changes will be active and stored in flash).
Shows information about policy conditions configured on the switch.
QoS Policy Commands
OmniSwitch CLI Reference Guide
March 2011