Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual page 1644

policy rule
policy rule
Configures a policy rule on the switch. A rule is made up of a condition (for classifying incoming traffic)
and an action (to be applied to outgoing traffic).
policy rule rule_name [enable | disable] [precedence precedence] [condition condition] [action action]
[validity-period name] [save] [log [log-interval seconds]] [count {packets | bytes}] [trap]
policy rule rule_name no {validity-period | save | log | trap}
no policy rule rule_name
Syntax Definitions
rule_name
enable
disable
precedence
condition
action
name
save
log
seconds
packets
bytes
trap
page 26-4
The name of the policy rule, any alphanumeric string.
Enables the policy rule.
Disables the policy rule.
The precedence value in the range 0–65535. This value determines the
order in which rules are searched for a matching condition. A higher
number indicates higher precedence. Typically the range 30000–65535
is reserved for PolicyView.
The condition name that is associated with this rule. Conditions are
configured through the policy condition command.
The name of the action that is associated with this rule. Actions are
configured through the policy action command.
The name of a user-defined validity period that is associated with this
rule. Validity periods are configured through the policy validity period
command.
Marks the policy rule so that it may be captured as part of the switch
configuration.
Configures the switch to log messages about specific flows coming into
the switch that match this policy rule.
Configures how often to look for packets that match this policy rule
when rule logging is applied (in the range from 0–3600 seconds). A
value of 0 specifies to log as often as possible.
Counts the number of packets that match the rule.
Counts the number of bytes that match the rule.
Enables or disables traps for the rule.
QoS Policy Commands
OmniSwitch CLI Reference Guide March 2011