QoS Policy Commands
policy condition destination udp-port
Configures a destination UDP port number for a policy condition.
policy condition condition_name destination udp-port port[-port]
policy condition condition_name no destination udp-port
Syntax Definitions
condition_name
port
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of the command to remove a destination UDP port from a condition; however, at least
one classification parameter must be associated with a condition.
•
This command is a shortcut for the
that the protocol also be specified. Rather than specifying destination ip-port and ip protocol, use
destination udp-port.
•
The same condition cannot specify a destination UDP port with a service or service group.
•
IP port protocol types cannot be mixed in the same condition; ports must be either TCP or UDP.
•
Use this condition in combination with the IPv6 condition (policy condition ipv6) to configure IPv6
policies for Layer 4 information, services, and service groups.
Examples
-> policy condition cond4 destination udp-port 137-138
-> policy condition cond5 ipv6 destination udp-port 140
-> policy condition cond4 no destination udp-port
Release History
Release 7.1.1; command was introduced.
OmniSwitch CLI Reference Guide
The name of the condition.
The UDP port number (or port range) of the destination address of the
Layer 3 flow, in the range from 0–65535. A range of ports (separated by
a hyphen) may be specified instead of a single port.
policy condition destination ip-port
March 2011
policy condition destination udp-port
command, which requires
page 26-63