Show Policy Map Group - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

show policy map group

show policy map group
Displays information about pending and applied policy map groups.
show [applied] policy map group [group_name]
Syntax Definitions
applied
group_name
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
Information for all policy map groups displays unless group_name is specified.
Examples
-> show policy map group
Group Name
State
Entries
output definitions
Group Name
State
Entries
page 26-162
Indicates that only map groups that have been applied should be
displayed.
The name of the policy map group for which you want to display infor-
mation; or a wildcard sequence of characters for displaying information
about map groups with similar names. Use an asterisk (*) to indicate a
wildcard character.
: m1
= new,
= 0:0,
1:9,
2:18,
3:27,
4:36,
5:45,
6:54,
7:63
The name of the map group, configured through the policy map group
command.
This field appears if the group was created or modified but not yet
applied to the QoS configuration. When the qos apply command is
issued, this field no longer displays.
The slot/port combinations associated with the port group.
QoS Policy Commands
OmniSwitch CLI Reference Guide March 2011