Ipv6 Pim Dense Group - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

PIM Commands

ipv6 pim dense group

Statically maps the specified IPv6 multicast group(s) to the PIM Dense mode (DM).
ipv6 pim dense group group_address/prefix_length [[no] override] [priority priority]
no ipv6 pim dense group group_address/prefix_length
Syntax Definitions
group_address
/prefix_length
override
priority
Defaults
By default, the priority option is not set and the override option is set to false.
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to remove a static configuration of a dense mode group mapping.
•
This command specifies the mode as Dense (PIM-DM) for the specified IPv6 multicast group
addresses.
•
If the group prefixes configured for two or more rows in this table overlap, the row with the greatest
prefix length value is used for the overlapping range.
•
Specifying the priority value obsoletes the override option and once the priority option has been
defined, a value of 65535 can be used to un-set the priority.
Examples
-> ipv6 pim dense group ff0e::1234/128 priority 50
-> no ipv6 pim dense group ff0e::1234/128
Release History
Release 7.1.1; command was introduced.
OmniSwitch CLI Reference Guide
Specifies the IPv6 multicast group address.
Specifies the prefix length of the IPv6 multicast group.
Specifies the static dense mode mapping configuration to override the
dynamically learned group mapping information for the specified
group(s).
Specifies the preference value to be used for this static configuration
and provides fine control over which configuration is overridden by this
static configuration. Values may range from 0 to 128.
March 2011
ipv6 pim dense group
page 23-79