ipv6 multicast querier-forwarding
ipv6 multicast querier-forwarding
Enables or disables MLD querier forwarding on the specified VLAN or on the system if no VLAN is spec-
ified.
ipv6 multicast [vlan vid] querier-forwarding [{enable | disable}]
no ipv6 multicast [vlan vid] querier-forwarding
Syntax Definitions
vid
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to remove an MLD querier forwarding entry on the specified VLAN
or on the system and return to its default behavior.
•
If the MLD querier forwarding is already enabled on the system, then the VLAN configuration will
override the system's configuration.
•
MLD querier forwarding refers to promoting detected MLD queriers to receive all IP multicast data
traffic.
Examples
-> ipv6 multicast querier-forwarding enable
-> ipv6 multicast querier-forwarding disable
-> ipv6 multicast querier-forwarding
-> ipv6 multicast vlan 2 querier-forwarding enable
-> ipv6 multicast vlan 2 querier-forwarding disable
-> ipv6 multicast vlan 2 querier-forwarding
-> no ipv6 multicast vlan 2 querier-forwarding
Release History
Release 7.1.1; command was introduced.
page 21-46
The VLAN on which configuration is applied.
Enable MLD querier forwarding.
Disable MLD querier forwarding.
default
disable
IP Multicast Switching Commands
OmniSwitch CLI Reference Guide
March 2011