Show Active Policy Rule - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

show active policy rule

show active policy rule
Displays information about pending and applied policy rules that are active (enabled) on the switch.
show active [bridged | routed | multicast] policy rule [rule_name]
Syntax Definitions
bridged
routed
multicast
rule_name
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the show policy rule command to display inactive as well as active policy rules.
•
Information for all rules is displayed unless rule_name is specified.
•
Information for all rule types is displayed unless a keyword (bridged, routed, multicast) is specified.
•
Applied rules may or may not be active on the switch. Applied rules are inactive if they have been
administratively disabled with the disable option in the policy rule command.
Examples
-> show active policy rule
Rule name
Condition name
Action name
Packets
Bytes
output definitions
Rule name
State
Condition name
page 26-168
Displays active rules that apply to bridged traffic.
Displays active rules that apply to routed traffic.
Displays active rules that apply to multicast traffic.
The name of the rule for which you want to display information; or a
wildcard sequence of characters for displaying information about rules
with similar names. Use an asterisk (*) to indicate a wildcard character.
: r1
= c1,
= a1,
= 4166772,
= 266665728
The name of the policy rule, configured through the
mand.
This field appears if the rule was created or modified but not yet
applied to the QoS configuration. When the qos apply command is
issued, this field no longer displays.
The name of the condition configured for this rule.
QoS Policy Commands
OmniSwitch CLI Reference Guide
policy rule com-
March 2011