Policy Action Maximum Depth - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

QoS Policy Commands

policy action maximum depth

Configures the maximum bucket size assigned to this action. The bucket size determines how much the
traffic can burst over the maximum bandwidth rate. When the bucket size is reached, the switch starts to
drop packets.
policy action action_name maximum depth bps[k | m | g | t]
policy action action_name no maximum depth
Syntax Definitions
action_name
bps[k | m | g | t]
Defaults
parameter
k | m | g | t
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to remove a maximum depth value from a policy action.
•
If the maximum depth value is specified as an integer, without an abbreviated unit designation, the
value is applied in kbps by default. For example, if the number 10 is specified, 10K is the maximum
depth value used. However, if 10G is specified, the maximum depth value applied is 10 gbps.
•
A maximum depth action is used in combination with a maximum bandwidth action.
Examples
-> policy action action2 maximum depth 100
-> policy action action2 no maximum depth
Release History
Release 7.1.1; command was introduced.
OmniSwitch CLI Reference Guide
The name of the action.
The maximum bucket size, in bits-per-second. The value may be
entered as an integer (for example, 10) or with abbreviated units (for
example, 10k, 5m, 1g).
default
k
March 2011
policy action maximum depth
page 26-127