Telnet - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

Session Management Commands

telnet

Invokes a Telnet session. A Telnet session is used to connect to a remote system or device.
telnet {port [default | service_port] | admin-state [enable | disable] | host_name | ip_address}
Syntax Definitions
default
service_port
enable | disable
host_name
ip_address
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
The default directory for Telnet is /flash.
Examples
-> telnet port 20999
-> telnet admin-state disable
-> telnet 172.17.6.228
Release History
Release 7.1.1; command was introduced.
Related Commands
ssh
MIB Objects
SystemServices
systemServicesArg1
systemServicesAction
OmniSwitch CLI Reference Guide
Sets the port back to the default of 23.
The TCP service port number. Must be 23 or between 20000-20999.
Enables or disables FTP access.
Specifies the host name for the Telnet session.
Specifies the IP address for the Telnet session.
Invokes the Secure Shell on the switch. A Secure Shell is used to make a
secured connection to a remote system or device.
March 2011
telnet
page 41-29