Show Ip Pim Dense Group - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

show ip pim dense group

show ip pim dense group
Displays the static configuration of multicast group mappings for PIM-Dense Mode (DM).
show ip pim dense group
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
If the group prefixes configured for two or more rows in this table overlap, the row with the greatest
prefix length value is used for the overlapping range.
•
This command is supported only on PIM dense mode.
Examples
-> show ip pim dense group
Group Address/Pref Length
---------------------------+-----+--------+----------+--------
224.0.0.0/4
output definitions
Group Address/Pref Length
Mode
Override
Precedence
Status
Release History
Release 7.1.1; command was introduced.
page 23-44
Mode Override Precedence Status
dm false none
The 32-bit IP address for a multicast group, along with the mask length,
shown in bits. The group IP address and mask are separated by a slash
( / ).
The PIM mode to be used for groups in this prefix. The possible values
include asm, ssm, or dm.
Specifies this static RP configuration to override the dynamically
learned RP information for the specified group(s).
Specifies the precedence value to be used for this static RP configura-
tion.
Displays whether this entry is currently enabled or disabled. Options
include enabled and disabled.
enabled
OmniSwitch CLI Reference Guide
PIM Commands
March 2011