Ipv6 Multicast Port Max-Group - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

ipv6 multicast port max-group

ipv6 multicast port max-group
Configures the maximum group limit learned per port. The limit is applicable on the given port for all
VLAN instances of the port.
ipv6 multicast port slot | port max-group [num] [action {none | drop | replace}]
Syntax Definitions
slot | port
num
none
drop
replace
Defaults
By default, the max-group limit is set to zero.
parameter
Action
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Configuring a max-group value will have no affect on existing group memberships until the member-
ships are refreshed on the port/VLAN instance.
•
The configuration is allowed even when the ip multicast status is disabled.
•
If the num and action parameters are not specified, then the limit is removed.
•
The max-group configuration on a port will override the VLAN or global configuration.
•
MLD zapping must be enabled when the max-group limit is enabled and the action is dropped.
Examples
-> ipv6 multicast port 1/1 max-group 10 action drop
-> ipv6 multicast port 1/1 max-group action replace
Release History
Release 7.1.1; command was introduced.
page 21-54
The slot number for the module and the physical port number on that
module (e.g. 3/1 specifies port 1 on slot 3).
The maximum MLD group count. Valid range is 0 to 4294967295.
Disables the maximum group limit configuration.
Drops the incoming membership request.
Replaces an existing membership with the incoming membership
request.
defaults
none
IP Multicast Switching Commands
OmniSwitch CLI Reference Guide March 2011