Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual page 1770

policy action cir
•
There is no explicit CLI command to configure the mode (srTCM or trTCM) in which the TCM meter
operates. Instead, the mode is determined by the CIR and PIR values configured for the policy action.
If the PIR value is greater than the CIR value, trTCM is used. If the PIR value is less than the CIR
value, srTCM is used.
•
Configuring CIR and CBS is similar to configuring a maximum bandwidth. Configuring CIR and PIR
is similar to configuring maximum depth.
•
The number of packets counted as a result of the counter color mode setting is displayed using the
show active policy rule command. These statistics are only shown for those rules that are configured
with a TCM policy action.
Examples
The following command examples configure srTCM (the default):
-> policy action A3 cir 10M
-> policy action A4 cir 10M cbs 4k
-> policy action A5 cir 10M cbs 4k pir 10M
-> policy action A6 cir 10M cbs 4k pir 10M pbs 4k
-> policy action a7 cir 5M cbs 2k color-only
-> policy action A3 no cir
-> policy action A5 no pir
The following command examples configure trTCM (note that PIR is greater than CIR):
-> policy action A7 cir 10M cbs 4k pir 20M
-> policy action A8 cir 10M cbs 4k pir 20M pbs 40M
-> policy action a9 cir 5M cbs 1M pbs 10M pbs 2M color-only
-> policy action A7 no cir
Release History
Release 7.1.1; command was introduced.
Related Commands
qos apply
policy action
show policy action
MIB Objects
alaQoSActionTable
alaQoSActionCIR
alaQoSActionCIRStatus
alaQoSActionCBS
alaQoSActionCBSStatus
alaQoSActionPIR
alaQoSActionPIRStatus
alaQoSActionPBS
alaQoSActionPBSStatus
alaQoSActionColorOnly
alaQoSAppliedActionTable
alaQoSAppliedActionCIR
alaQoSAppliedActionCIRStatus
page 26-130
Applies configured QoS and policy settings to the current configuration.
Creates a policy action.
Displays information about policy actions.
QoS Policy Commands
OmniSwitch CLI Reference Guide March 2011