ipv6 pim dense admin-state
ipv6 pim dense admin-state
Enables or disables the IPv6 PIM-DM (dense mode) globally for IPv6.
ipv6 pim dense admin-state {enable | disable}
Syntax Definitions
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 10K
Usage Guidelines
This command must be set to enable before PIM-DM can run on the switch. In addition, the ip load pim
command must be executed. Refer to
Examples
-> ipv6 pim dense admin-state enable
-> ipv6 pim dense admin-state disable
Release History
Release 7.1.1; command was introduced.
Related Commands
ipv6 pim interface
ip load pim
show ipv6 pim dense
MIB Objects
alaPimdmGlobalConfig
alaPimdmV6AdminStatus
page 23-76
Enables PIM-DM globally for IPv6.
Disables PIM-DM globally for IPv6.
default
disable
page 23-3
for more information.
Enables or disables the PIM protocol on a specific interface.
Dynamically loads PIM to memory.
Displays the status of the various global parameters for the IPv6
PIM dense mode.
OmniSwitch CLI Reference Guide
PIM Commands
March 2011