Show Violation - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

Learned Port Security Commands

show violation

Displays the address violations that occur on ports with LPS restrictions. This command displays a port
violation for sticky port security when the maximum number of MAC address of the connected
workstation that the switch learns.
show violation {port slot/port[-port2] | linkagg linkagg_id[-linkagg_id2]}
Syntax Definitions
slot/port
-port2
linkagg_id
-linkagg_id2
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
NA
Examples
-> show violation
Port Source
------+----------+-------------------+----------------+--------
1/1 src lrn
1/1 src lrn
' '2 '''''''qos' ' ' '
The admin down action in the show violation output for port 2 represents that there has been a port
violation on one of the ports related to the link aggregate group with ID 2.
output definitions\
Port
Source
OmniSwitch CLI Reference Guide
The slot number for the module and the physical port number on that
module (for example, 3/1 specifies port 1 on slot 3).
The last port number in a range of ports (for example, 3/1-4 specifies
ports 1-4 on slot 3).
Enter a link aggregate ID number.
The last aggregate ID number in a range of link aggregate ports.
Action
simulated down lps shutdown
simulated down lps restrict
admin down policy
The slot and port numbers or link aggregate IDs of the ports that list
address violations.
Specifies the source application that detects the violation.
March 2011
Reason Timer
0
0
0
show violation
page 30-17