Ip Multicast Robustness - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

IP Multicast Switching Commands

ip multicast robustness

Sets the IGMP robustness variable on the specified VLAN or on the system if no VLAN is specified.
ip multicast [vlan vid] robustness [robustness]
Syntax Definitions
vid
robustness
Defaults
parameter
robustness
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
IP Multicast Switching and Routing must be enabled to set the IGMP robustness variable on the system
and/or the specified VLANs.
•
If the IGMP robustness variable is already configured on the system, then the VLAN configuration will
override the system's configuration.
•
Robustness variable allows fine-tuning on the network, where the expected packet loss would be
greater.
•
To restore the IGMP robustness variable to its default (i.e., 2) value on the system if no VLAN is spec-
ified, use ip multicast robustness followed by the value 0 (e.g., ip multicast robustness 0) or use only
ip multicast robustness (e.g., ip multicast robustness).
•
To restore the IGMP robustness variable to its default (i.e., 2) value on the specified VLAN, use
ip multicast vlan vid robustness followed by the value 0 (e.g., ip multicast vlan 2 robustness 0) or use
only ip multicast vlan vid robustness (e.g., ip multicast vlan 2 robustness).
Examples
-> ip multicast robustness 3
-> ip multicast robustness 0
-> ip multicast robustness
-> ip multicast vlan 2 robustness 3
-> ip multicast vlan 2 robustness 0
-> ip multicast vlan 2 robustness
Release History
Release 7.1.1; command was introduced.
OmniSwitch CLI Reference Guide
VLAN on which to apply the configuration.
IGMP robustness variable. Valid range is 1 to 7.
default
2
March 2011
ip multicast robustness
page 21-35