Debug Qos - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

debug qos

debug qos
Configures the type of QoS events that will be displayed in the QoS log.
debug qos [info] [config] [rule] [main] [port] [msg] [sl] [ioctl] [mem] [mapper] [slot] [l2] [l3] [classi-
fier] [nat] [sem] [pm] [ingress] [egress]
debug no qos
debug no qos [info] [config] [rule] [main] [port] [msg] [sl] [ioctl] [mem] [mapper] [slot] [l2] [l3] [clas-
sifier] [nat] [sem] [pm] [ingress] [egress]
Syntax Definitions
rule
l2
l3
nat
port
msg
classifier
info
config
main
sl
mem
mapper
slot
sem
pm
ingress
egress
Defaults
By default basic information messages are logged (info). Error messages are always logged.
Platforms Supported
OmniSwitch 10K
page 25-18
Logs events for rules configured on the switch.
Logs Layer 2 QoS events on the switch.
Logs Layer 3 QoS events on the switch.
Logs events for Network Address Translation policies. Not supported
for the OmniSwitch 6624/6648.
Logs events related to QoS ports.
Logs QoS messages.
Logs information whenever the switch classifies a flow; more details are
provided if the log level is higher.
Logs basic information about the switch
Logs information about the global configuration.
Logs information about basic program interfaces.
Logs information about source learning.
Logs information about memory.
Logs information about mapping queues.
Logs events related to slots.
Logs information about semaphore, process locking.
Logs events related to the Policy Manager.
Logs information about packets arriving on the switch.
Logs information about packets leaving the switch.
OmniSwitch CLI Reference Guide
QoS Commands
March 2011