Qos Trust-Ports - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

QoS Commands

qos trust-ports

Configures the global trust mode for QoS ports. Trusted ports can accept 802.1p and ToS/DSCP values in
incoming packets; untrusted ports will set any 802.1p or ToS/DSCP values to zero in incoming packets,
unless a default 802.1p or ToS/DSCP value is configured.
Any port configured through the qos port command will automatically be added in the trust mode speci-
fied by this command. See
qos trust-ports
qos no trust-ports
Syntax Definitions
N/A
Defaults
By default, all ports are untrusted.
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the qos ports trusted command to override the default for a particular port.
•
The setting only applies to ports with incoming traffic.
•
Any port configured for 802.1Q tagging is always trusted regardless of the global setting.
•
Mobile ports are always trusted regardless of the global setting.
•
Use the qos port default 802.1p
zero should be applied to the incoming packets. Note that this value is overridden if a policy exists that
specifies a different value for such packets.
Examples
-> qos trust-ports
-> qos no trust-ports
Release History
Release 7.1.1; command was introduced.
OmniSwitch CLI Reference Guide
page 25-30 for more information about this command.
or qos port default dscp
March 2011
commands to specify that a value other than
qos trust-ports
page 25-5