Snmp Station - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

SNMP Commands

snmp station

Adds a new SNMP station; modifies or deletes an existing SNMP station.
snmp station {ip_address | ipv6_address} {[udp_port] [username] [v1 | v2 | v3] [enable | disable]}
no snmp station {ip_address | ipv6_address}
Syntax Definitions
ip_address
ipv6_address
udp_port
username
v1
v2
v3
enable
disable
Defaults
parameter
udp_port
v1 | v2 | v3
enable | disable
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of the command to remove an existing SNMP station.
•
When adding an SNMP station, you must specify an IP address plus username parameters. For exam-
ple, the syntax snmp station 1.2.3.4 is not a valid command entry; however, snmp station 1.2.3.4
username1 is a valid command entry.
•
When modifying an SNMP station, you must specify an IP address plus at least one additional
parameter. For example, the syntax snmp station 1.2.3.4 is not a valid command entry; however,
snmp station 1.2.3.4 v2 is a valid command entry.
•
When the SNMP station is enabled, the switch transmits traps to the specified IP or IPv6 address.
OmniSwitch CLI Reference Guide
The IP address to which SNMP unicast traps will be sent.
The IPv6 address to which SNMP unicast traps will be sent.
A UDP destination port.
The user name on the switch or external server used to send traps to the
SNMP station(s). The username specified here must match an
existing user account name.
Specifies that traps are sent using SNMP version 1.
Specifies that traps are sent using SNMP version 2.
Specifies that traps are sent using SNMP version 3.
Enables the specified SNMP station.
Disables the specified SNMP station.
default
162
v3
enable
March 2011
snmp station
page 45-3