Policy Condition Destination Ip-Port - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

QoS Policy Commands

policy condition destination ip-port

Configures a destination IP port number for a policy condition.
policy condition condition_name destination ip-port port[-port]
policy condition condition_name no destination ip-port
Syntax Definitions
condition_name
port
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of the command to remove a destination IP port from a condition; however, at least
one classification parameter must be associated with a condition.
•
The protocol (TCP or UDP) must be specified in the same condition, either on the same command line
or in a previous command. Use the ip protocol keywords. See the
command.
•
The same condition cannot specify a destination IP port with a service or service group.
Examples
-> policy condition cond2 ip protocol 6 destination ip-port 137-138
Release History
Release 7.1.1; command was introduced.
Related Commands
qos apply
policy condition ip-protocol
show policy condition
OmniSwitch CLI Reference Guide
The name of the condition.
The TCP or UDP port number (or port range) of the destination address
of the Layer 3 flow, in the range from 0–65535. A range of ports (sepa-
rated by a hyphen) may be specified instead of a single port.
Applies configured QoS and policy settings to the current configuration.
Configures an IP protocol for a policy condition.
Shows information about policy conditions configured on the switch.
March 2011
policy condition destination ip-port
policy condition ip-protocol
page 26-55