Network Time Protocol Commands
ntp client
Enables or disables NTP time synchronization discipline.
ntp client admin-state {enable | disable}
Syntax Definitions
enable
disable
Defaults
NTP protocol is disabled by default.
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use this command to enable or disable NTP. Before NTP can be enabled, an NTP server must be spec-
ified using the
ntp server
•
It is not necessary to specify an NTP server if the NTP client will only receive time updates from NTP
broadcast servers.
Examples
-> ntp client enable
-> ntp client disable
Release History
Release 7.1.1; command was introduced.
Related Commands
ntp server
MIB Objects
alaNtpEnable
OmniSwitch CLI Reference Guide
Enables NTP.
Disables NTP.
command. Up to 3 NTP servers may be defined.
Specifies an NTP server from which the switch will receive updates.
March 2011
ntp client
page 40-7