Sflow Sampler - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

sflow sampler

sflow sampler
Gets the hardware sampled from Q-dispatcher and fills up the sampler part of the UDP datagram.
sflow sampler num port slot/port[-port] {receiver receiver_index | rate value | sample-hdr-size size}
no sflow sampler num portlist
Syntax Definitions
num
slot/port
receiver_index
value
size
portlist
Defaults
parameter
receiver_index
value
size
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to delete a sampler.
•
A sampling rate of 1 counts all packets. A sampling rate of 0 disables sampling.
Examples
-> sflow sampler 1 2/1 receiver 1 rate 5 sample-hdr-size 64
-> no sflow sampler 1 2/1-5
Release History
Release 7.1.1; command was introduced.
page 32-6
Specifies the instance id.
The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
Specifies the receiver index.
Specifies the rate value for packet sampling.
Specifies the maximum number of bytes (size) that can be copied from a
sampled packet.
Specifies the interface index range.
default
0
0
128
OmniSwitch CLI Reference Guide
sFlow Commands
March 2011