Ntp Key - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

Omniswitch series
Table of Contents

Advertisement

Network Time Protocol Commands

ntp key

Labels the specified authentication key identification as trusted or untrusted.
ntp key key [trusted | untrusted]
Syntax Definitions
key
trusted
untrusted
Defaults
By default, all authentication key are untrusted.
Platforms Supported
OmniSwitch 10K
Usage Guidelines
Authentication keys are stored in a key file and loaded into memory when the switch boots. The keys
loaded into memory are not trusted until this command is used.The location of the file containing set of
generated authentication keys is /flash/network/ntp.keys.
Once the keys are loaded into software (on boot up of the switch), they must be activated by being
labeled as trusted. A trusted key will authenticate with a server that requires authentication as long as
the key matches the server key.
New keys must be added manually to the key file. A newly added key will not be loaded into the
switch software until the
An authentication key is composed of a 32-bit integer and 32-byte string of characters. The integer
format is hexadecimal. For an NTP message to be authenticated the NTP client authentication key
must match the key configured at the NTP server. This means the authentication keys must be distrib-
uted in advance of configuring the NTP client. If authentication is disabled but authentication key is
present, the association will still be unauthenticated.
By default all keys read from the ntp.conf key file are untrusted therefore keys must be set to 'trusted'
status to allow NTP to use the key for authentication.
Examples
-> ntp key 5 trusted
-> ntp key 2 untrusted
OmniSwitch CLI Reference Guide
The key number matching an NTP server.
Signifies that the specified key is trusted and can be used for authentica-
tion.
Signifies that the specified key is not trusted and cannot be used for
authentication. Synchronization will not occur with an untrusted authen-
tication key.
ntp key load
command is issued, or the switch is rebooted.
March 2011
ntp key
page 40-11

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Omniswitch 10k

Table of Contents