CMM Commands
show running-directory
Shows the current state of version and configuration management for a CMM.
show running-directory
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Once a switch boots up and is running, it runs either from the working, certified, or a user-defined
directory. If the switch is running from the certified directory, changes made to the RUNNING
CONFIGURATION using CLI commands, cannot be saved.
Examples
The following is an example of the display on OmniSwitch 10K switches:
-> show running-directory
CONFIGURATION STATUS
Running CMM
CMM Mode
Current CMM Slot
Running configuration
Certify/Restore Status
SYNCHRONIZATION STATUS
Flash Between CMMs
Running Configuration
output definitions
Running CMM
CMM Mode
Current CMM Slot
Running Configuration
Certify/Restore Status
OmniSwitch CLI Reference Guide
: PRIMARY,
: MONO CMM,
: A,
: CERTIFIED,
: CERTIFIED,
: SYNCHRONIZED
: SYNCHRONIZED
The CMM currently controlling the switch, either PRIMARY or
SECONDARY.
Whether there are one or two CMMs installed.
The slot of the primary CMM, A or B.
The current RUNNING DIRECTORY.
Indicates if the CMM has been certified.
March 2011
show running-directory
page 37-17