Snmp-Trap Filter-Ip - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

snmp-trap filter-ip

snmp-trap filter-ip
Enables or disables SNMP trap filtering. Trap filtering is used to determine whether a trap or group of
traps will be sent from the switch to a specified SNMP station.
snmp-trap filter-ip {ip_address | ipv6_address} trap_id_list
no snmp-trap filter-ip {ip_address | ipv6_address} trap_id_list
Syntax Definitions
ip_address
ipv6_address
trap_id_list
Defaults
By default, SNMP trap filtering is disabled.
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
To enable trap filtering, use the syntax
•
To disable trap filtering, use the syntax
•
When filtering is enabled, the specified trap(s) will not be sent to the SNMP station. When filtering is
disabled, the specified traps will be sent to the SNMP station.
•
To display a list of traps and their ID numbers, use the
Examples
-> snmp-trap filter-ip 172.1.2.3 1
-> snmp-trap filter-ip 172.1.2.3 0 1 3 5
-> snmp-trap filter-ip 300::1 1 3 4
-> no snmp-trap filter-ip 172.1.2.3 1
-> no snmp-trap filter-ip 172.1.2.3 0 1 3 5
-> no snmp-trap filter-ip 300::1 1 3
page 45-22
The IP address for the SNMP station for which trap filtering is being
enabled or disabled.
The IPv6 address for the SNMP station for which trap filtering is being
enabled or disabled.
Specifies the trap(s) for which filtering is being enabled or disabled.
Traps must be specified using the numeric trap ID. You can specify
more than one trap in the command line; separate each trap ID with a
space and no comma.
snmp-trap filter-ip
no snmp-trap filter-ip
show snmp-trap config
ip_address trap_id_list.
ip_address trap_id_list.
command.
OmniSwitch CLI Reference Guide
SNMP Commands
March 2011