show ipv6 multicast
output definitions
Query Response Interval
(milliseconds)
Last Member Query Interval
(milliseconds)
Unsolicited Report Interval
(seconds)
Router Timeout (seconds)
Source Timeout (seconds)
Release History
Release 7.1.1; command was introduced.
page 21-106
Displays the time (in milliseconds) to reply to an MLD query message.
(The default value is 10000 milliseconds.) You can modify this parame-
ter with the
ipv6 multicast query-response-interval
is described on
page
21-66.
Displays the time (in milliseconds) to reply to an MLD query message
sent in response to a leave group message. (The default value is 1000
milliseconds.) You can modify this parameter with the
ipv6 multicast last-member-query-interval
described on
page
21-64.
Displays the time period (in seconds) to proxy any changed MLD
membership state. (The default value is 1 second). You can modify this
parameter with the
ipv6 multicast unsolicited-report-interval
mand, which is described on
Displays the MLD router timeout in seconds (The default value is 90
seconds.) You can modify this parameter with the
ipv6 multicast router-timeout
21-70
Displays the IGMP source timeout in seconds (The default is 30 sec-
onds.) You can modify this parameter with the
ipv6 multicast source-timeout
21-72
IP Multicast Switching Commands
command, which is
page
21-68.
command, which is described on
command, which is described on
OmniSwitch CLI Reference Guide
command, which
com-
page
page
March 2011