Ntp Peer - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

ntp peer

ntp peer
Configures NTP to operate in the symmetric active peering mode.This also enables the establishment of an
active symmetric association with the specified remote peer.
ntp peer {ip-address} [key keyid] [version version] [minpoll poll interval]
no ntp peer {ip-address}
Syntax Definitions
ip-address
key-id
version
poll interval
Defaults
Parameter
version
poll interval
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use no form of this command to remove the peers that are configured to act in symmetric active
mode.This command deletes the symmetric active association with the remote peer.
•
Use the version keyword to set the correct version of NTP.
•
Use the minpoll keyword to set the minimum poll time for the server. This number is determined by
raising 2 to the power of the number entered.
•
The command should not be used for b(Broadcast ), m(Multicast) or r(Reference clock address
127.127.x.x)
•
ip-address is the mandatory parameter to be entered in the command while key id is the optional
parameter. If key id is not specified, then peering will not be authenticated.
Examples
-> ntp peer 172.18.16.112
-> no ntp peer 172.18.16.112
page 40-20
IP address of the remote peer.
Authentication key for the remote peer.
NTP packet version to be used for the peer association.
Polling interval for NTP broadcast message. Poll interval which when
expires, packets will be sent to the peer.
Default
4
6
Network Time Protocol Commands
OmniSwitch CLI Reference Guide March 2011