Show Ipv6 Pim Sparse - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

show ipv6 pim sparse

show ipv6 pim sparse
Displays the status of the various global parameters for the IPv6 PIM sparse mode.
show ipv6 pim sparse
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
N/A
Examples
-> show ipv6 pim sparse
Status
Keepalive Period
Max RPs
Probe Time
Register Suppress Timeout
RP Switchover
SPT Status
output definitions
Status
Keepalive Period
Max RPs
Probe Time
Register Suppress Timeout
page 23-92
= enabled,
= 210,
= 32,
= 5,
= 60,
= enabled,
= enabled,
The current global (i.e., switch-wide) status of the IPv6 PIM sparse
mode. Options include enabled and disabled.
The duration of the Keepalive timer. The default value is 210.
The maximum number of Rendezvous Points (RPs) allowed in the IPv6
PIM-SM domain (1–100). The default value is 32.
The amount of time before the Register Suppression timer expires, at
which point the Designated Router (DR) sends a Null Register message
to the Rendezvous Point (RP). This allows the RP to refresh the Regis-
ter-Stop. If the Register Suppression timer expires, the DR will resume
encapsulating packets from the source to the RP. Values may range
from 1 to 300. The default value is 5.
The amount of time, in seconds, the Designated Router (DR) will stop
sending registers to the Rendezvous Point (RP) once a Register-Stop is
received (1–300). The default value is 60.
OmniSwitch CLI Reference Guide
PIM Commands
March 2011