Snmp Security - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

SNMP Commands

snmp security

Configures SNMP security settings.
snmp security {no-security | authentication set | authentication all | privacy set | privacy all | trap-
only}
Syntax Definitions
no-security
authentication set
authentication all
privacy set
privacy all
trap-only
Defaults
By default, the SNMP security default is set to privacy all, which is the highest level of security.
Platforms Supported
OmniSwitch 10K
Usage Guidelines
Refer to the table below for a quick-reference list of security parameter and the SNMP request allowances
for each parameter.
no-security
authentication set
authentication all
privacy set
privacy all
trap-only
OmniSwitch CLI Reference Guide
The switch will accept all SNMP v1, v2, and v3 requests.
The switch will accept all requests except v1, v2, and non-authenticated
v3 set requests. SNMP v1, v2, and non-authenticated v3 set requests
will be rejected.
The switch will accept all requests except v1, v2, and non-authenticated
v3 get, get-next, and set requests. SNMP v1, v2, and non-authenticated
v3 get, get-next, and set requests will be rejected.
The switch will accept only authenticated SNMP v3 get, get-next and
encrypted v3 set requests. All other requests will be rejected.
The switch will accept only encrypted v3 get, get-next, and set requests.
All other requests will be rejected.
All SNMP get, get-next, and set requests will be rejected.
v1 set v1 get
v2 set v2 get
v3 non-auth v3 non-auth get/
set get-next
accepted accepted
rejected accepted
rejected rejected
rejected rejected
rejected rejected
rejected rejected
March 2011
v3 auth set v3 auth get/
get-next
accepted accepted
accepted accepted
accepted accepted
rejected accepted
rejected rejected
rejected rejected
snmp security
v3 encryp set v3 encryp get/
get-next
accepted accepted
accepted accepted
accepted accepted
accepted accepted
accepted accepted
rejected rejected
page 45-11