Show Policy Validity Period - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

show policy validity period

show policy validity period
Displays information about policy validity periods.
show policy validity period [name]
Syntax Definitions
name
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Information for all validity periods is displayed unless name is specified.
•
Use the show policy rule
Examples
-> show policy validity-period
Validity period name
State
Days
Validity period name
Months
-> show applied policy validity-period
Validity period name
Months
output definitions
Validity period name
State
Days
Months
page 26-172
The name of the validity period.
command to display the validity period that is associated with a policy rule.
= tuesday
= new,
= tuesday
= february
= february
= february
= february
The name of the policy validity period, configured through the
validity period command.
This field appears if the validity period was created or modified but not
yet applied to the QoS configuration. When the qos apply command is
issued, this field no longer displays.
The days of the week the validity period is active, configured through
the policy validity period
the validity period is not restricted to specific days.
The months during which the validity period is active, configured
through the policy validity period
appear, then the validity period is not restricted to specific months.
QoS Policy Commands
command. If this field does not appear, then
command. If this field does not
OmniSwitch CLI Reference Guide
policy
March 2011