Ipv6 Multicast Vlan Max-Group - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

ipv6 multicast vlan max-group

ipv6 multicast vlan max-group
Configures the maximum group limit learned per port on a VLAN. The limit is applied to each port that is
a member of the given VLAN.
ipv6 multicast vlan vid max-group [num] [action {none | drop | replace}]
Syntax Definitions
vid
num
none
drop
replace
Defaults
By default, the max-group limit is set to zero.
parameter
Action
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Configuring a max-group value will have no affect on existing group memberships until the member-
ships are refreshed on the port/VLAN instance.
•
The configuration is allowed even when the ip multicast status is disabled.
•
If the num and action parameters are not specified, then the limit is removed.
•
The max-group configuration on a VLAN will override the global configuration.
•
MLD zapping must be enabled when the max-group limit is enabled and the action is dropped.
Examples
-> ipv6 multicast vlan 10 max-group 10 action drop
-> ipv6 multicast vlan 10 max-group 20 action replace
Release History
Release 7.1.1; command was introduced.
page 21-52
VLAN on which to apply the configuration.
The maximum MLD group count. Valid range is 0 to 4294967295.
Disables the maximum group limit configuration.
Drops the incoming membership request.
Replaces an existing membership with the incoming membership
request.
defaults
none
IP Multicast Switching Commands
OmniSwitch CLI Reference Guide March 2011