Qos Port Default Classification - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

qos port default classification

qos port default classification
Specifies the default egress priority value to use for IP traffic ingressing on trusted ports.
qos port slot/port[-port] default classification {tos | 802.1p | dscp}
Syntax Definitions
slot/port[-port]
tos
802.1p
dscp
Defaults
parameter
tos | 802.1p | dscp
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
The egress priority assigned to an IP packet received on a trusted port is based on the DSCP value of
the packet unless 802.1p is specified using this command.
•
The default classification priority is not used if there is a matching QoS policy rule that sets the egress
priority value.
•
This command does not affect Layer 2 traffic, which is always classified with 802.1p.
•
In some network situations, some IP traffic may be dropped before any QoS rules can take effect for
the traffic.
Examples
-> qos port 8/24 default classification dscp
-> qos port 4/1-8 default classification dscp
-> qos port 7/1 default classification 802.1p
-> qos port 5/1-8 default classification 802.1p
Release History
Release 7.1.1; command was introduced.
page 25-44
The slot number and port number of the physical port. Use a hyphen to
specify a range of ports (4/1-8).
Specifies that the ToS value of the flow will be used to prioritize flows
coming in on the port.
Specifies that the 802.1p value of the flow will be used to prioritize
flows coming in on the port.
Specifies that the DSCP value of the flow will be used to prioritize
flows coming in on the port.
default
dscp
OmniSwitch CLI Reference Guide
QoS Commands
March 2011