Ip Interface Tunnel - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

DVMRP Commands

ip interface tunnel

Configures the end points for the GRE and IPIP tunnels.
ip interface name tunnel [source ip_address] [destination ip_address] [protocol {ipip | gre}]
no ip dvmrp interface name
Syntax Definitions
name
source ip_address
destination ip_address
ipip
gre
Defaults
parameter
ipip | gre
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
You can configure an interface as either a vlan or tunnel interface.
•
The maximum number of GRE tunnel interfaces that can be configured on a switch is 8.
•
The maximum number of IPIP tunnel interfaces that can be configured on a switch is 127.
•
Use the no form of this command to remove an IP interface.
Examples
-> ip interface "tnl-1" tunnel source 23.23.23.1 destination 155.2.2.2 protocol gre
-> ip interface "tnl-1" tunnel source 23.23.23.1 destination 155.2.2.2 protocol
ipip
Release History
Release 7.1.1; command introduced
OmniSwitch CLI Reference Guide
Text string up to 20 characters. Use quotes around string if description
contains multiple words with spaces between them (e.g. "Alcatel-Lucent
Marketing"). Note that this value is case sensitive.
Source IP address of the tunnel.
Destination IP address of the tunnel.
Specifies the tunneling protocol as IPIP.
Specifies the tunneling protocol as GRE.
default
ipip
March 2011
ip interface tunnel
page 22-17