Ipv6 Multicast Query-Interval - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

ipv6 multicast query-interval

ipv6 multicast query-interval
Sets the MLD query interval on the specified VLAN or on the system if no VLAN is specified.
ipv6 multicast [vlan vid] query-interval [seconds]
Syntax Definitions
vid
seconds
Defaults
parameter
seconds
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
IPv6 Multicast Switching and Routing must be enabled to set the MLD query interval on the system
and/or the specified VLANs.
•
If the MLD query interval is already configured on the system, then the VLAN configuration will over-
ride the system's configuration.
•
The MLD query interval refers to the time period between MLD query messages.
•
To restore the MLD query interval to its default (i.e., 125 seconds) value on the system if no VLAN is
specified, use ipv6 multicast query-interval followed by the value 0 (e.g., ipv6 multicast query-inter-
val 0) or use only ipv6 multicast query-interval (e.g., ipv6 multicast query-interval).
•
To restore the MLD query interval to its default (i.e., 125 seconds) value on the specified VLAN, use
ipv6 multicast vlan vid query-interval followed by the value 0 (e.g., ipv6 multicast vlan 2 query-
interval 0) or use only ipv6 multicast vlan vid query-interval (e.g., ipv6 multicast vlan 2 query-inter-
val).
Examples
-> ipv6 multicast query-interval 100
-> ipv6 multicast query-interval 0
-> ipv6 multicast query-interval
-> ipv6 multicast vlan 2 query-interval 100
-> ipv6 multicast vlan 2 query-interval 0
-> ipv6 multicast vlan 2 query-interval
Release History
Release 7.1.1; command was introduced.
page 21-62
VLAN on which to apply the configuration.
MLD query interval in seconds. Valid range is 1 to 65535.
default
125
IP Multicast Switching Commands
OmniSwitch CLI Reference Guide March 2011