Show Ntp Client Server-List - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

show ntp client server-list

show ntp client server-list
Displays a list of the servers with which the NTP client synchronizes.
show ntp client server-list
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
Use this command to display tabular information on the current NTP client to server association status.
Examples
-> show ntp client server-list
IP Address
================+===+=======+====+==========+=================+==========
*198.206.181.70
=198.206.181.123
output definitions
IP Address
Ver
Key
St
Delay
Offset
Disp
page 40-26
Ver Key St
4 0 2 0.167
4 0 16 0.000
The server IP address.
"+" indicates an active peer
"-" indicates a pasive peer
"=" indicates a client
"*" indicates current system peer
"^" indicates a broadcast server
"`" indicates a broadcast client
The version of NTP the server is using. Versions 3 and 4 are valid.
The NTP server's public key. This must be accurate and the same as the
NTP server, or the client switch will not be able to synchronize with the
NTP server. A zero (0) means there is no key entered.
The stratum of the server.
The delay received from the server in its timestamp.
The offset received from the server in its timestamp.
The dispersion value received from the server in its timestamp.
Delay Offset
0.323
0.000
OmniSwitch CLI Reference Guide
Network Time Protocol Commands
Disp
0.016
0.000
March 2011