Policy Server Commands - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

This chapter describes CLI commands used for managing policies downloaded to the switch from an
attached LDAP server. Policy rules can be created on an attached server through the PolicyView GUI
application. Policy rules can also be created on the switch directly through CLI or SNMP commands. This
chapter describes commands related to managing LDAP policies only. See
for information about commands for creating and managing policies directly on the switch.
The policy commands are based on RFC 2251 and RFC 3060.
MIB information for policy server commands is as follows:
Filename: alcatelIND1policy.mib
Module: ALCATEL-IND1-POLICY-MIB
The policy server commands are summarized here:
policy server load
policy server flush
policy server
show policy server
show policy server long
show policy server statistics
show policy server rules
show policy server events
OmniSwitch CLI Reference Guide
27 Policy Server
March 2011
Commands
Chapter 25, "QoS Commands,"
page 27-1