Policy Condition Established - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

QoS Policy Commands

policy condition established

Configures an established TCP connection as a policy condition. A connection is considered established if
the ack or rst flags in the TCP header of the packet are set.
policy condition condition_name established
policy condition condition_name no established
Syntax Definitions
condition_name
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to remove established from a condition; however, at least one classi-
fication parameter must be associated with a condition.
•
When an initial TCP connection packet is received only the syn flag is set. As a result, TCP packets are
only examined if they are not the starting packet.
•
Typically this condition is used in combination with source ip, destination ip, source port, destina-
tion port, source TCP port, or destination TCP port conditions.
•
Note that even though established can be used with most action parameters, it is mainly intended for
ACL use.
Examples
-> policy condition cond2 source ip 192.168.5.10 established
-> policy condition cond3 destination ip 10.255.11.40
Release History
Release 7.1.1; command was introduced.
Related Commands
qos apply
policy condition
show policy condition
OmniSwitch CLI Reference Guide
The name of the condition.
Applies configured QoS and policy settings to the current configuration.
Creates a policy condition.
Shows information about policy conditions configured on the switch.
March 2011
policy condition established
page 26-67