Ethernet-Service Sap Uni - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

ethernet-service sap uni

ethernet-service sap uni
Configures the switch port as a VLAN Stacking User Network Interface (UNI) and associates the port
with a VLAN Stacking Service Access Point (SAP). A UNI port is a customer facing port on which
traffic enters the SAP.
ethernet-service sap {sap_id} uni {port slot/port[-port2] | linkagg linkagg_id [-linkagg_id2]}
no ethernet-service sap {sap_id} uni {port slot/port[-port2] | linkagg linkagg_id [-linkagg_id2]}
Syntax Definitions
sap_id
slot/port
-port2
linkagg_id
-linkagg_id2
Defaults
A switch port or a link aggregate becomes a VLAN Stacking UNI port by default when the port or link
aggregate is associated with a VLAN Stacking SAP.
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to remove an association between a UNI port and a SAP. Note that
when the last SAP association is removed, the UNI port converts back to a conventional switch port.
•
Only fixed ports can be configured as UNI ports.
•
The SAP ID specified with this command must already exist. Use the ethernet-service sap command
to create a SAP.
•
When this command is used, the default VLAN for the UNI port is changed to a reserved VLAN and
all customer traffic received is dropped until the type of traffic for the port is configured using the
ethernet-service sap cvlan command.
Examples
-> ethernet-service sap 10 uni port 1/3
-> ethernet-service sap 10 uni port 2/10-15
-> ethernet-service sap 10 uni linkagg 31-40
-> no ethernet-service sap 10 uni port 1/10-15
-> no ethernet-service sap 10 uni linkagg 31
page 34-14
The SAP ID number identifying the service instance.
The slot number for the module and the physical port number on that
module (for example, 3/1 specifies port 1 on slot 3).
The last port number in a range of ports that you want to configure on
the same slot (for example, 3/1-4 specifies ports 1, 2, 3, and 4 on slot 3).
The link aggregate ID number.
The last link aggregate ID number in a range of aggregates that you
want to configure.
VLAN Stacking Commands
OmniSwitch CLI Reference Guide March 2011