Policy Condition Icmptype - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

policy condition icmptype

policy condition icmptype
Configures an ICMP type value to use for traffic classification.
policy condition condition_name icmptype type
policy condition condition_name no icmptype
Syntax Definitions
condition_name
type
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
Use the no form of the command to remove an ICMP type value from a condition; however, at least one
classification parameter must be associated with a condition.
Examples
-> policy condition cond12 icmptype 100
Release History
Release 7.1.1; command was introduced.
Related Commands
policy condition icmpcode
policy condition
qos apply
show policy condition
page 26-74
The name of the condition.
The ICMP type value, in the range 0–255.
Configures an ICMP code value for traffic classification.
Creates a policy condition.
Applies configured global QoS and policy settings to the current config-
uration (changes will be active and stored in flash).
Shows information about policy conditions configured on the switch.
QoS Policy Commands
OmniSwitch CLI Reference Guide March 2011