Show Policy Network Group - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

show policy network group

show policy network group
Displays information about pending and applied policy network groups.
show [applied] policy network group [network_group]
Syntax Definitions
applied
network_group
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
Information for all policy network groups displays unless network_group is specified.
Examples
-> show policy network group
Group Name
State
Entries
-> show policy network group
Group Name
Entries
output definitions
Group Name
State
Entries
page 26-152
Indicates that only network groups that have been applied should be
displayed.
The name of the policy network group for which you want to display
information; or a wildcard sequence of characters for displaying infor-
mation about network groups with similar names. Use an asterisk (*) to
indicate a wildcard character.
: netg1
= new,
= 198.206.10.1
: group1
= 203.185.129.0 mask 255.255.255.0,
203.185.131.192 mask 255.255.255.192,
203.185.132.0 mask 255.255.252.0,
204.226.0.0 mask 255.255.0.0
The name of the port group, configured through the policy network
group command.
This field appears if the group was created or modified but not yet
applied to the QoS configuration. When the qos apply command is
issued, this field no longer displays.
The IP addresses associated with the network group.
QoS Policy Commands
OmniSwitch CLI Reference Guide March 2011