Ip Mroute-Boundary - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

Multicast Routing Commands

ip mroute-boundary

Adds or deletes scoped multicast address boundaries for a router interface. When a user on the specified
interface joins the multicast group as defined by the scoped address—plus the mask length—all multicast
traffic will stop being forwarded on that interface. This provides a mechanism for the end user to control
multicast traffic from the network.
Refer to the "Configuring Multicast Address Boundaries" chapter in the applicable OmniSwitch Advanced
Routing Guide for detailed information.
ip mroute-boundary if_name scoped_address mask
no ip mroute-boundary if_name scoped_address mask
Syntax Definitions
if_name
scoped_address
mask
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
Use the no form of this command to delete the scoped multicast address boundaries for a router interface.
Examples
-> ip mroute-boundary vlan-2 239.0.0.0 255.0.0.0
Release History
Release 7.1.1; command was introduced.
Related Commands
show ip mroute-boundary
OmniSwitch CLI Reference Guide
The interface name on which the boundary is being assigned.
A scoped multicast address identifying the group range for the bound-
ary. Scoped addresses may range from 239.0.0.0–239.255.255.255.
A corresponding Class A, B, or C mask address (e.g., 255.0.0.0).
Displays scoped multicast address boundaries for the switch's
router interfaces.
March 2011
ip mroute-boundary
page 24-3