Ipv6 Multicast Zapping - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

ipv6 multicast zapping

ipv6 multicast zapping
Enables or disables MLD zapping on the specified VLAN or on the system if no VLAN is specified.
ipv6 multicast [vlan vid] zapping [{enable | disable}]
Syntax Definitions
vid
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
If the MLD zapping is already enabled on the system, then the VLAN configuration will override the
system's configuration.
•
MLD zapping refers to processing membership and source filter removals immediately and not wait-
ing for the protocol's specified time period. This mode facilitates IP TV applications looking for quick
changes between IP multicast groups.
•
You can also restore the MLD zapping to its default (i.e., disabled) setting on the system if no VLAN is
specified, by using only ipv6 multicast zapping (e.g., ipv6 multicast zapping).
•
You can also restore the MLD zapping to its default (i.e., disabled) setting on the specified VLAN, by
using only ipv6 multicast vlan vid zapping (e.g., ipv6 multicast vlan 2 zapping).
Examples
-> ipv6 multicast zapping enable
-> ipv6 multicast zapping disable
-> ipv6 multicast zapping
-> ipv6 multicast vlan 2 zapping enable
-> ipv6 multicast vlan 2 zapping disable
-> ipv6 multicast vlan 2 zapping
Release History
Release 7.1.1; command was introduced.
page 21-80
VLAN on which to apply the configuration.
Enable MLD zapping.
Disable MLD zapping.
default
disable
IP Multicast Switching Commands
OmniSwitch CLI Reference Guide March 2011