Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual page 2025

Switch Logging Commands
level
Supported Levels Numeric Equivalents Description
alarm
error
alert
warning
info
debug1
debug2
debug3
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
When the switch logging display is too long, you may use the
the switch logging information.
•
This command can also be used on the secondary CMM.
Examples
-> show log swlog
Displaying file contents for 'swlog2.log'
FILEID: fileName[swlog2.log], endPtr[32]
configSize[64000], currentSize[64000], mode[2]
Displaying file contents for 'swlog1.log'
FILEID: fileName[swlog1.log], endPtr[395]
configSize[64000], currentSize[64000], mode[1]
Time Stamp
------------------------+--------------+-------+--------------------------------
MON NOV 11 12:42:11 2002
command
MON NOV 11 13:07:26 2002
l!
MON NOV 11 13:18:24 2002
l!
MON NOV 11 13:24:03 2002
OmniSwitch CLI Reference Guide
A numerical equivalent value for the severity level (see table below).
All switch logging messages of the specified level and lower will be
shown. The severity level is a value assigned to the relative severity of
the switch logging message. A lower value indicates messages that are
more severe, a higher value indicates messages that are less severe.
Values range from 2–9.
2
3
4
5
6
7
8
9
Application
SYSTEM
TELNET
March 2011
Highest severity. The system is about to crash and reboot.
System functionality is reduced.
A violation has occurred.
A unexpected, non-critical event has occurred.
Any other non-debug message (default).
A normal event debug message.
A debug-specific message.
Lowest severity. A maximum verbosity debug message.
show log swlog
Level Log Message
info Switch Logging files cleared by
WEB info The HTTP session login successfu
WEB info The HTTP session login successfu
info New telnet connection, Address ,
show log swlog
command to clear all of
page 35-11