Policy Condition Source Ip-Port - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

QoS Policy Commands

policy condition source ip-port

Configures a source IP port number for a policy condition.
policy condition condition_name source ip-port port[-port]
policy condition condition_name no source ip-port
Syntax Definitions
condition_name
port
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of the command to remove a source IP port from a condition; however, at least one
classification parameter must be associated with a condition.
•
The protocol (TCP or UDP) must be specified in the condition, either on the same command line or in
a previous command. Use the ip protocol keywords. See the
•
The same condition cannot specify a source IP port with a source TCP port, source UDP port, service,
or service group.
Examples
-> policy condition cond1 ip protocol 6 source ip-port 137
Release History
Release 7.1.1; command was introduced.
Related Commands
qos apply
policy condition ip-protocol
show policy condition
OmniSwitch CLI Reference Guide
The name of the condition.
The TCP or UDP port number of the source address of the Layer 3 flow,
in the range from 0–65535. A range of ports (separated by a hyphen)
may be specified instead of a single port.
Applies configured QoS and policy settings to the current configuration.
Configures an IP protocol for a policy condition.
Shows information about policy conditions configured on the switch.
March 2011
policy condition source ip-port
policy condition ip-protocol command.
page 26-53